Primary Chain Tensioner

[gasman]

Does anyone have or have there engine apart a tensioner that I could copy as I'm not happy with the previous one I made. Or make a drawing with dimensions, Thanks Kev

[Smokey_Paul]

which bit do you need as the blade is from a T150?

[gasman]

I didn't have anything, I guessed at the base plate and made a (thing), not too good so would like to try and make a better one.

[Smokey_Paul]

Kev the adjuster does not require a lot of science it is just a flat plate with a nut welded on the bottom side, thru this goes the adjuster screw which pushes up on the T150 slipper blade which is held on one end by a pivot post and thats it.

I was told that people have had to strengthen the base plate as it can twist and bend under pressure but mine looked fine.

[gasman]

I think i have sorted it. I had the pivit too far back. Now moved and all seems fine

Sent from Samsung mobile

"Smokey_Paul [via Silk Motorcycles]" wrote:

Kev the adjuster does not require a lot of science it is just a flat plate with a nut welded on the bottom side, thru this goes the adjuster screw which pushes up on the T150 slipper blade which is held on one end by a pivot post and thats it.

I was told that people have had to strengthen the base plate as it can twist and bend under pressure but mine looked fine.

---

If you reply to this email, your message will be added to the discussion below:

http://silk-motorcycles.6084.x6.nabble.com/Primary-Chain-Tensioner-tp5000843p5000850.html

To start a new topic under Silk Motorcycles, email [hidden email]
To unsubscribe from Silk Motorcycles, click here.
NAML